the unarchiver you need to supply the file name

#THE UNARCHIVER YOU NEED TO SUPPLY THE FILE NAME INSTALL#
#THE UNARCHIVER YOU NEED TO SUPPLY THE FILE NAME ARCHIVE#
#THE UNARCHIVER YOU NEED TO SUPPLY THE FILE NAME FULL#

Note : The Raspberry Pi OS with desktop image contained in the ZIP archive is over 4GB in size and uses the ZIP64 format. Step 3: Unzip the package downloaded and you will see the.

#THE UNARCHIVER YOU NEED TO SUPPLY THE FILE NAME INSTALL#

There are three different kinds of Raspberry Pi OS system available, You are recommend to install the version： Raspberry Pi OS with desktop and recommended software. Step 2: Download the complete image on the official website by clicking this link. You can download the software from the link: Step 1: Prepare the tool of image burning. If this is not done, Raspberry Pi Imager will fail with a “failed to write” error. Note : If using the Raspberry Pi Imager on Windows 10 with Controlled Folder Access enabled, you will need to explicitly allow the Raspberry Pi Imager permission to write the SD card.

Review your selections and click ‘WRITE’ to begin writing data to the SD card.

Choose the SD card you wish to write your image to.

#THE UNARCHIVER YOU NEED TO SUPPLY THE FILE NAME FULL#

Open Raspberry Pi Imager and choose Raspberry Pi OS (other) -> Raspberry Pi OS Full (32-bit).

Connect an SD card reader with the SD card inside.

Download the latest version of Raspberry Pi Imager( ) and install it.

Raspberry Pi have developed a graphical SD card writing tool that works on Mac OS, Ubuntu 18.04 and Windows, and is the easiest option for most users as it will download the image and install it automatically to the SD card. But once you successfully finish the flashing at the first time, it only takes about 10 minutes to flash again. In the later method, you need to download Raspberry Pi OS image at first, then use the tool to write it to your SD card, which can be confusing. However, each time the system is reinstalled, this method can take several hours. Using Raspberry Pi Imager is a kind of method recommended by Raspberry Pi official website for beginners with which you can directly write the Raspberry Pi OS into SD card after downloading Raspberry Pi Imager. There are 2 ways to install the system, Using Raspberry Pi Imager or Using Raspberry Pi OS. If we don’t have a screen, we can directly write the Raspberry Pi OS system to the Micro SD card and we can control the Raspberry Pi on PC remotely by directly modifying the configuration file of the network settings in the Micro SD card. Note: You can check the complete tutorial of NOOBS on the official website of the Raspberry Pi.

Here, you are suggested to use the former. Here is the download address of Noobs: Step 1: To download NOOBS from your PC, you can choose NOOBS or NOOBS LITE – the only difference is that there is a built-in offline Raspberry Pi OS installer in NOOBS, while the NOOBS LITE can only be operated online. If you have a screen, you can use the NOOBS to install the Raspberry Pi OS system. Otherwise, please find the corresponding steps in later parts of this chapter. If you have a separate screen for Raspberry Pi, follow the instructions eariler in this chapter. If you are a beginner, please follow this chapter to let your Raspberry Pi work.ĭepending on the different devices you use, you can start up the Raspberry Pi in different methods. If you have installed the other two versions, you need to install the following softwares manually and then skip this chapter.

In this chapter, configure your Raspberry Pi first.įor the Raspberry Pi OS (previously called Raspbian) system, You are recommend to install the version: Raspberry Pi OS (32-bit) with desktop and recommended software.

The unarchiver you need to supply the file name